About Online StyleChopper PCB SplitterWhat are the common problems?

In daily production, although the blade type PCB splitter is simple to use, it always encounters problems like this. The editor has compiled five small points for your reference only.

1. If the indicator light does not light up after the power switch of the cutter PCB divider is turned on:

One possibility is that the fuse segment needs to be replaced; Another possibility is that the emergency switch is not turned on.

2Chopper PCB SplitterThe itinerary is not accurate:

One possibility is that the travel counter is faulty and needs to be replaced; Another possibility is that the travel counter has too much dust, just clear the dust.

3. The cutter of the PCB divider collides with the left board:

One possibility is that the left travel light sensing switch is damaged and needs to be replaced; Another possibility is that the left travel switch has too much dust, which can be cleared.

4. The knife of the PCB cutting machine collides with the right board:

One possibility is that the right travel light sensing switch is damaged and needs to be replaced; Another possibility is that the right travel switch has too much dust, which can be cleared.

5. The motor of the PCB cutting machine rotates, but the knife does not rotate:

The top screw of the coupling is loose. Open the rear shell and tighten the top screw.

The above are the five daily problems and solutions for the online chopper PCB splitter.